Removing And Installing Cover For Centre Underbody At The Sides

Unscrew nuts -3- .
Unscrew screws -2- and remove underbody cover at the sides -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Removing underbody cover at the sides
Installation is performed in reverse order. Pay particular attention to the following:
Tightening torque for nut on centre underbody cover at the sides: > Tightening torque 2.7 (1.75 ftlb.) Nm +/- 0.2 (0.1 ftlb.) Nm

Tightening torque for screw on centre underbody cover at the sides: > Tightening torque 2.7 (1.75 ftlb.) Nm +/- 0.2 (0.1 ftlb.) Nm