Removing Wing Joining Plate

Information 

• Some of the repair illustrations show only one side of the vehicle or a similar component. 
• Naturally, some steps also have to be performed on the opposite side of the vehicle as well. 

Fig 1: Wing Joining Plate Component Location

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Front wing joining plate

1. Drill through clinch points using a drill bit. > Diameter 6.5 mm  .
2. Drill through punch rivets -A-  using a > Nr.201 - twist drill. 

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Removing wing joining plate

3. heat up bonding areas using a hot-air gun.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Loosening bonding areas

4. Remove wing joining plate.