Installing Front Seat (Sports Bucket Seat)
- Danger of injury
- Loss of torque
→ Always use new screws or nuts following removal.
→ Comply with instructions for repairs.
→ Observe specified tightening torques.
→ Carry out a visual inspection of parts used.
- Risk of damage to lines and hoses
- Malfunction and fault memory entry on control unit
→ Avoid small bending radii when routing lines.
→ File down edges and burrs in the routing area or mask them with adhesive tape.
→ Maintain a sufficient distance from components exposed to high temperatures while driving.
Information
- Replace fastening screws (micro-self-locking).
Information
The routing of the wire harness for the control unit must be checked before installing the seat.
The wire harness must not be routed over the cover, but should be laid alongside the cover.
Information
Before installing and securing the front seat, make sure the electric lines are not pinched or damaged.
- Installation is performed in reverse order as opposed to removal.
- Tighten screws with tightening torque.
> Tightening torque 50 N.m (36.9 ft lb.)
> Tightening torque 50 N.m (36.9 ft lb.)
> Tightening torque 50 N.m (36.9 ft lb.)