Installing Passenger Airbag Unit
WARNING: This page is about a different variant/trim than selected.
WARNING:
Incorrect handling of safety bolts
- Danger of injury
- Loss of torque
→ Always use new screws or nuts following removal.
→ Comply with instructions for repairs.
→ Observe specified tightening torques.
→ Carry out a visual inspection of parts used.
Information
Always replace fastening screws and nuts on the airbag unit after customer service and reworking.
- Installation is performed in reverse order. Pay particular attention to the following:
Screw in and tighten screws securing passenger's airbag unit to cross member > Tightening torque 9.7 Nm (7.2 ftlb.)