Installing Airbag Sensor On Inner A-Pillar
WARNING: This page is about a different variant/trim than selected.
Information
- Make sure that the airbag sensor is positioned correctly.
Information
Always use a new nut following removal.
- Installation is performed in reverse order. Pay particular attention to the following:
Align airbag sensor with positioning pin in the slot of the A-pillar.
Leave a gap of at least 5 mm from the sound absorber. Cut the sound absorber if necessary.
Tightening torque for nut securing airbag sensor to inner A-pillar: > Tightening torque 9 Nm (6.6 ftlb.)