Installing Line For ATF Cooling
WARNING: This page is about a different variant/trim than selected.
- Installation is performed in reverse order. Pay particular attention to the following:
- 1.1 Tighten screw securing line connection to transmission.
> Tightening torque 20 Nm (15 ftlb.)
- 1.2 Tighten screw on bracket for ATF cooling line.
> Tightening torque 8 Nm (6 ftlb.)
- 1.3 Tighten screws securing exhaust system holder to automatic transmission.
> Tightening torque 23 Nm (17 ftlb.)
- 1.4 Tighten screw securing holder to exhaust system.
> Tightening torque 23 Nm (17 ftlb.)
- 1.1 Tighten screw securing line connection to transmission.