Installing Sealing Ring For Front Output Shaft

WARNING: This page is about a different variant/trim than selected.

Prepare new sealing ring for fitting.

1.1 Make sure not to bend the sealing lip -Arrow- .

1.2 Fill the space between the dust and sealing lips on the new sealing ring with Olista Longtime 3EP grease. When doing this, make sure that the sealing lip -Arrow- is also coated slightly with grease.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Sealing ring

Clean the take-up bore and shaft.
Slide new sealing ring -2- over > T10186 - protective sleeve-1- and shaft and remove > T10186 - protective sleeve-1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Protective sleeve T10186 and sealing ring
Drive a new sealing ring -1- using a > 9831 - pressure piece-2- onto the > press-in depth 6.6 mm +/- 0.3 mm -x- . The maximum inclination of the sealing ring must be 0.5 mm.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Sealing ring with pressure piece 9831
Fit new sealing ring -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Cover ring