Installing Rear Output Shaft Seal

WARNING: This page is about a different variant/trim than selected.

NOTE: Dirt and contamination

Risk of damage to units or components
→ Protect components from dirt and contamination.

→ Clean or replace dirty components.

> 9894 - Sleeve-2- must be positioned on the output shaft, then slide on a new seal -1- with the raised side (lock ring) facing the transmission.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Seal with guide sleeve
Tap in new seal until flush using > 9833 - pressure piece .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Tapping in seal with pressure piece
Remove tools.
Screw in new standard nut ("small" collar) using > 9933 - socket for transmission shaft nut and tighten it if the large collar nut -1- was fitted beforehand.
> Tightening torque 218 Nm (161 ftlb.) +/- 5 Nm (3.5 ftlb.)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Large collar nut on PDK output shaft
Fit dust boot.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Dust boot on output shaft
Fit new circlip -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Circlip on rear output shaft