Installing Pressure Sensor
WARNING: This page is about a different variant/trim than selected.
NOTE:
Dirt and contamination
- Risk of damage to units or components
→ Protect components from dirt and contamination.
→ Clean or replace dirty components.
Information
- The sealing ring on the pressure sensor is pressed on.
- After removing a pressure sensor, the sensor must be replaced.
- Lightly coat sealing ring on the pressure sensor with new hydraulic oil.
- Screw in the relevant pressure sensor by hand.
- Tighten pressure sensor using > 9911 - socket-wrench insert
.
> Tightening torque 12 Nm (9 ftlb.)
- Connect cable plug and check that it is seated securely.