Torque Support

WARNING: This page is about a different variant/trim than selected.

Fig 1: Torque Support Components Location With Torque Specification (V8 Turbo)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Torque support (shown on V8 Turbo)

1	Torque support
2	Replace screw, M10 x 70 + M10 x 80 > Initial tightening 50 Nm (36.9 ftlb.) > torque angle + 90°
3	Torque support bracket
4	Screw > Tightening torque 55 Nm (40.6 ftlb.)
5	Screws, M8 x 55 (V6 Turbo M8 x 45) > Tightening torque 23 Nm (17 ftlb.)