Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance1 | Tolerance2 |
|---|---|---|---|---|---|
| Screws for engine carrier | M10 x 35 | Tightening torque | 50 Nm (37 ftlb.) | ||
| Fastening screw on vacuum reservoir | Tightening torque | 9 Nm (6.5 ftlb.) | |||
| Fastening nut for vacuum reservoir | Tightening torque | 9 Nm (6.5 ftlb.) | |||
| Screw for stopper on camshaft | Tightening torque | 9 Nm (6.5 ftlb.) | |||
| Control valve for camshaft controller for outlet camshaft | Initial tightening | 30 Nm (22 ftlb.) | |||
| Control valve for camshaft controller for outlet camshaft | Final tightening | + 35° | |||
| Control valve for camshaft controller for intake camshaft | Initial tightening | 30 Nm (22 ftlb.) | |||
| Control valve for camshaft controller for intake camshaft | Final tightening | + 35° | |||
| Screw plug securing crankshaft | Replace | Tightening torque | 40 Nm (29.5 ftlb.) |