Installing Heat Shield
WARNING: This page is about a different variant/trim than selected.
- Position heat shield -1-
on the front-axle carrier.
 Courtesy of PORSCHE CARS NORTH AMERICA, INC.
|
Installation overview of heat shield
- Fit and tighten screws -2 and 3-
on the heat shield -1-
.
 Courtesy of PORSCHE CARS NORTH AMERICA, INC.
|
Screws on heat shield
- 2.1 M8 screw -3-
: > Tightening - torque 20 Nm (15 ftlb.)
- 2.2 M6 screws -2-
: > Tightening - torque 9 Nm (6.5 ftlb.)