Installing Connecting Link For Anti-Roll Bar
WARNING: This page is about a different car, the 2024 Porsche Macan, 2023 Porsche Macan, 2022 Porsche Macan, 2021 Porsche Macan, and 2020 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
- Installation is performed in reverse order. Pay particular attention to the following:
- 1.1 Replace screw and nut securing connecting link for anti-roll bar to anti-roll bar.
- 1.2 Tighten screw and nut securing connecting link for anti-roll bar to anti-roll bar.
> Initial - tightening 50 Nm (37 ftlb.)
> Final tightening + 90°
- 1.3 Replace screw securing connecting link for anti-roll bar to lower trailing arm.
- 1.4 Tighten screw securing connecting link for anti-roll bar to lower trailing arm.
> Initial - tightening 50 Nm (37 ftlb.)
> Final tightening + 90°