Subsequent Work
WARNING: This page is about a different car, the 2024 Porsche Macan, 2023 Porsche Macan, 2022 Porsche Macan, 2021 Porsche Macan, and 2020 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
- Install rear speed sensor.
> 451519 - REMOVING AND INSTALLING REAR SPEED SENSOR - PORTION ON "INSTALLING"
- Depending on equipment:
Install coil spring or air spring bellows.
> 427219 - REMOVING AND INSTALLING COIL SPRING - PORTION ON "INSTALLING"
> 434319 - REMOVING AND INSTALLING AIR SUSPENSION BELLOWS - PORTION ON "INSTALLING"
- Install rear brake disc.
> 465319 - REMOVING AND INSTALLING REAR BRAKE DISC - PORTION ON "INSTALLING"
- Tighten screw for drive shaft -1-
.
Drive shaft screw
- 4.1 Raise the vehicle as far as required so that the wheel is not on the floor.
- 4.2 Tighten screw on drive shaft -1-
to the specified initial tightening torque and get a second mechanic to press the brake at the same time.
> Initial - tightening 200 Nm (148 ftlb.)
- 4.3 Lower the vehicle.
- 4.4 Tighten screw on drive shaft -1-
and also get a second mechanic to press the brake at the same time.
> Final tightening 180°
- 4.5 Fit hub cap -2- .
- Perform suspension alignment.