Tightening Sequence For High-Pressure Fuel Lines
WARNING: This page is about a different car, the 2024 Porsche Macan, 2023 Porsche Macan, 2022 Porsche Macan, 2021 Porsche Macan, and 2020 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
- Fit union nut -1-
by hand.
- 1.1 Coat thread on union nuts with Microgleit DF 977S. Observe drying time of at least 5 minutes before fitting.
- Tighten screws -2- with > tightening - torque 8 Nm (5.9 ftlb.) > final - tightening torque + 45 Nm (33.2 ftlb.)
- Screw -3- with > Tightening - torque 9 Nm (6.6 ftlb.)
- Union nut -1- with > tightening - torque of 10 Nm (7.4 ftlb.) > Torque angle 60°
Tightening sequence for high-pressure fuel lines V6 biturbo