Intake-Air Distributor - V6 Monoturbo And Biturbo

WARNING: This page is about a different car, the 2024 Porsche Macan, 2023 Porsche Macan, 2022 Porsche Macan, 2021 Porsche Macan, and 2020 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Intake-Air Distributor Component Location With Torque Specification - V6 Monoturbo And Biturbo

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

intake-air distributor - V6 monoturbo and biturbo

1	Centre intake-air distributor
2	Pressure sensor
3	Screw > Tightening - torque 5 Nm (3.5 ftlb.)
4	O-ring /replace
5	Throttle valve
6	Screws > Tightening - torque 7 Nm (5 ftlb.)
7	Seal /replace if damaged
8	Screws > Tightening - torque 7 Nm (5 ftlb.)
9	Seal /replace if damaged
10	Intake-air distributor, left and right
11	Seal /replace if damaged
12	Screws, M6 x 25/observe specified tightening sequence > Initial - tightening 8 Nm (6 ftlb.) > Final tightening + 45°
13	Screw > Tightening - torque 8 Nm (6 ftlb.)

Fig 2: Throttle Housing Component Location With Torque Specification

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Throttle housing

2	Screw-type clamp > Tightening - torque 5.5 Nm (4 ftlb.)