Installing Hydraulic Valve For Valve Lift Switchover

WARNING: This page is about a different car, the 2024 Porsche Macan, 2023 Porsche Macan, 2022 Porsche Macan, 2021 Porsche Macan, and 2020 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Installation is performed in reverse order. Pay particular attention to the following:
1. 1.1 Replace screws on hydraulic valve for valve lift switchover.
2. 1.2 Tighten screws on hydraulic valve for valve lift switchover.
  - Initial tightening 3 Nm (2 ftlb.)
  - Torque angle + 90°
3. 1.3 Tighten screws for ground lines.
  - Tightening torque 9 Nm (6.5 ftlb.)
4. 1.4 Only after removing hydraulic valve for valve lift adjustment on right cylinder bank:
  Tighten screws on torque support bracket.
  - Tightening torque 20 Nm (15 ftlb.)