Subsequent Work
WARNING: This page is about a different car, the 2024 Porsche Macan, 2023 Porsche Macan, 2022 Porsche Macan, 2021 Porsche Macan, and 2020 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
- Install new
crankshaft sealing ring (flywheel side).
- 135955 Replacing crankshaft sealing ring - flywheel side (V6 turbo)
- Install flywheel.
- 136019 Removing and installing flywheel (V6 turbo)
- Install pulse sender.
- 287319 Removing and installing pulse sender (V6 turbo)
- Install upper chain housing cover.
- 153319 Removing and installing upper chain housing cover (V6 turbo)
- Only after removing upper chain housing cover on right cylinder bank:
Install additional coolant pump holder -1- .
- 1.1
Position additional coolant pump holder -1-
, fit double screw securing holder to chain housing cover -3-
and tighten it.
- Tightening torque 9 Nm (6.5 ftlb.)
- 1.2
Fit and tighten screws securing additional coolant pump to holder -2-
.
- Tightening torque 1.5 Nm (1 ftlb.)
Additional coolant pump (right cylinder bank)
- 1.1
Position additional coolant pump holder -1-
, fit double screw securing holder to chain housing cover -3-
and tighten it.
- For engine with particle filter
Install particle filter.
- 267419 Removing and installing particle filter
- For engine without particle filter
Install catalytic converter.
- 267319 Removing and installing catalytic converter
- Install the engine.
- 100119 Removing and installing engine
- Fill up coolant.
- 193817 Draining and filling coolant