Removing Lower Chain Housing (V6 Turbo)

WARNING: This page is about a different car, the 2024 Porsche Macan, 2023 Porsche Macan, 2022 Porsche Macan, 2021 Porsche Macan, and 2020 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Unscrew upper screws securing lower chain housing cover -1- to both cylinder banks.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Upper screws on lower chain housing cover
Remove lower chain housing cover -3- .
1. 2.1 Unscrew screw on coolant line holder -2- .
2. 2.2 Unscrew screws on lower chain housing cover -1- .
3. 2.3 Screw one screw into each of the threaded bores -Arrows- by hand.
4. 2.4 Tighten screws carefully and uniformly in order to loosen the lower chain housing cover -3- from the bonding.
5. 2.5 Remove lower chain housing cover -3- .
6. 2.6 Unscrew screws used for loosening from the lower chain housing cover -3- .
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Lower chain housing cover

Information
- Sealing faces must be cleaned to remove all residual sealant.
- Sealing faces must be free of grease and oil.
- Sealing faces must be cleaned with primer Loctite 7515.
Clean sealing faces.
Remove crankshaft sealing ring (flywheel side).
- 135955 Replacing crankshaft sealing ring - flywheel side (V6 turbo)