Securing Rear Brake Calliper

WARNING: This page is about a different car, the 2024 Porsche Macan, 2023 Porsche Macan, 2022 Porsche Macan, 2021 Porsche Macan, and 2020 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Remove fastening element -2- and remove rear brake calliper -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Rear brake calliper in wheel housing

Information

Never use power tools (impact bolter) for loosening and securing the brake calliper on the wheel bearing housing.
Secure rear brake calliper -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Rear brake calliper
1. 2.1 Fit rear brake calliper -1- .
2. 2.2 Replace rear brake calliper screws -3- .
3. 2.3 Screw in and tighten new screws on rear brake calliper -3- .
  > Initial - tightening 100 Nm (74 ftlb.)
  
  > Final tightening + 90°
4. 2.4 Connect and lock cable plug -2- .
Push on and lock cable plug for rpm sensor -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Cable plug for rpm sensor
Commission electric parking brake (EPB) using the PIWIS Tester.
1. 4.1 Select Parking brake in the control unit overview.
2. 4.2 In the Maintenance/repairs menu, select the function Commissioning.
3. 4.3 Follow the instructions on the Tester.