Installing Front Brake Caliper

WARNING: This page is about a different car, the 2024 Porsche Macan, 2023 Porsche Macan, 2022 Porsche Macan, 2021 Porsche Macan, and 2020 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Installation is performed in reverse order. Pay particular attention to the following:
1. 1.1 Reset brake pads using > 9472 - brake piston resetting fixture.
2. 1.2 Replace screws securing brake calliper to wheel bearing housing.
3. 1.3 Tighten screws securing brake caliper to wheel bearing housing.
  Brake 18-inch - red:
  
  > Initial - tightening 30 Nm (22 ftlb.)
  
  > Final tightening + 90°
  
  19-inch PCCB/PSCB:
  - Initial tightening 30 Nm (22 ftlb.)
  - Final tightening + 90°
4. 1.4 Tighten brake pipe/brake hose on brake calliper.
  Grey cast iron/PSCB:
  
  > Tightening - torque 20 Nm (15 ftlb.)
  
  PCCB:
  
  > Tightening - torque 14 Nm (10.5 ftlb.)
5. 1.5 Tighten screw securing brake line bracket to wheel bearing housing.
  > Tightening - torque 8 Nm (6 ftlb.)
6. 1.6 Position disc brake pads by pressing the brake pedal several times.