Securing Front Brake Calliper

WARNING: This page is about a different car, the 2024 Porsche Macan, 2023 Porsche Macan, 2022 Porsche Macan, 2021 Porsche Macan, and 2020 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Remove fastening element -2- and remove front brake calliper -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Front brake calliper in wheel housing (shown as an example)
Secure front brake calliper -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Screws for front brake calliper
1. 2.1 Position front brake calliper -1- on wheel bearing housing.
2. 2.2 Replace front brake calliper screws -2- .
3. 2.3 Screw in and tighten new screws on front brake calliper -2- .
  Grey cast iron (18-inch):
  
  > Initial - tightening 30 Nm (22 ftlb.)
  
  > Final tightening + 90°
  
  PCCB:
  
  > Initial - tightening 30 Nm (22 ftlb.)
  
  > Final tightening + 90°
Carefully insert contact for brake pad wear indicator -1- and secure electric line -2- to the bleeder valve cover at the brake calliper -3- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Wire harness for brake pad wear indicator
Secure brake line holder -1- on wheel bearing housing.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Brake line holder
1. 4.1 Fit brake line holder -1- .
2. 4.2 Screw in and tighten screw on brake line holder -2- .
  > Tightening - torque 8 Nm (6 ftlb.)
Position disc brake pads by pressing the brake pedal several times.
Check brake fluid level in the reservoir -Arrow- and correct it if necessary.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Brake fluid level