Removing Balance Shaft Bearing

WARNING: This page is about a different car, the 2024 Porsche Macan, 2023 Porsche Macan, 2022 Porsche Macan, 2021 Porsche Macan, and 2020 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Prepare the > T40395 - insertion tool .

1.1 Fit adapter T40395/2 on the roller bearing at the correct side. The chamfer -Arrow- must be facing the roller bearing.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Adapter T40395/2

1.2 Align adapter -T40395/3- . The side without the chamfer -Arrows- points downwards

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Adapter T40395/3

Pull the roller bearing inward at the front -1- and rear -2- using the spindle -T40395/1- . adapter -T40395/2- and adapter -T40395/3- as far as it will go by turning the nut -T40395/4- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Using special tool T40395