Installing Drive Plate

WARNING: This page is about a different car, the 2024 Porsche Macan, 2023 Porsche Macan, 2022 Porsche Macan, 2021 Porsche Macan, and 2020 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

NOTIFICATION

Dirt and contamination

Risk of damage to units or components
1. → Protect components from dirt and contamination.
2. → Clean or replace dirty components.

Position Hall sender rotor -1- and check position of centering pin -Arrow- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Hall sender rotor
Fit the drive plate, check the position of the centering pin and secure the drive plate with a new screw.
Position the > 10-201 - bracket-1- with two washers -2- on the drive plate -3- as shown -Arrow- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

on drive plate
Secure the drive plate -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Drive plate
1. 4.1 Replace screws -2- and tighten in diagonally opposite sequence.
2. 4.2 Tighten new screws -2- in diagonally opposite sequence using > VAS 6942 - torque/torque angle wrench, 20-400 Nm .
  - pre-tightening 60 Nm (44.3 ftlb.)
  - final-tightening + 90°