Mounting Double Clutch Transmission
WARNING: This page is about a different car, the 2024 Porsche Macan, 2023 Porsche Macan, 2022 Porsche Macan, 2021 Porsche Macan, and 2020 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Danger of objects or loads falling down
- Risk of squashing or crushing
→ Secure components to prevent them from falling down.
- Check that the intermediate plate on the joint flange is engaged and pushed onto the dowel sleeves -1-
. Replace missing dowel sleeves -1-
if necessary.
Dowel sleeves
- Check that the locking element of the starter -1-
is inserted correctly and move it into installation position if necessary -Arrows-
.
Locking element of starter
- Fit double clutch transmission.
- 3.1 Screw in screws on double clutch transmission -1 to 5- as far as they will go by hand.
- 3.2
Tighten screws on double clutch transmission -1 and 2-.
> Initial - tightening 30 Nm (22 ftlb.)
> Final tightening + 105°
- 3.3
Tighten screw on double clutch transmission -3-.
> Initial - tightening 30 Nm (22 ftlb.)
> Final tightening + 105°
- 3.4
Tighten screw on double clutch transmission -5-.
> Initial - tightening 15 Nm (11 ftlb.)
> Final tightening + 105°
- 3.5
Tighten screws on double clutch transmission -4-.
> Initial - tightening 15 Nm (11 ftlb.)
> Final tightening + 105°
Courtesy of PORSCHE CARS NORTH AMERICA, INC.
Flange screws securing engine to transmission
- Secure the starter
- > T40294 - Hook and support tool must new be retrieved
- Tighten new screws on drive plate.