LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2019 >> Macan Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 17 (37 Automatic Transmission - Actuator, Housing 2.9L -- 95B - MACAN (95B)) >> WM, 370819 Removing And Installing Shift Console >> Removing Shift Console >> Installing Support

Installing Support

WARNING: This page is about a different car, the 2024 Porsche Macan, 2023 Porsche Macan, 2022 Porsche Macan, 2021 Porsche Macan, and 2020 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Information 

Do not apply lateral forces to the selector knob pull rod as it can break off.

  1. Install selector support 3  .
    G15153158Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Selector support and locking cable

    1. 1.1  Guide locking cable 2  into selector support -3-  and engage safety clip -1-  .
    2. 1.2  Position selector support -3-  .
  2. Install heat shield -1-  .
    G15153159Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Heat shield

    1. 2.1  Position heat shield -1-  .
    2. 2.2  Tighten clamping washers 2  .
  3. Secure transmission support 2  .
    G15153160Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Transmission support

    1. 3.1  Lift transmission and transmission support using > VAS 6931 - engine and gearbox jack  .
    2. 3.2  Fit and tighten screws -1 and 3-  .

      > Tightening - torque 70 Nm (52 ftlb.) 

    3. 3.3  > VAS 6931 - Engine and gearbox jack  must now be removed.

      Information 

      • Loosen clamping screw for locking cable by only about 1 turn.
      • The clamping screw is only accessible in selector-lever position "P".
      • When the clamping screw is loosened, the selector lever must remain in position "P".
  4. Secure selector support.
    1. 4.1  Position selector support.
    2. 4.2  Fit and tighten nuts 4  .

      > Tightening - torque 8 Nm (6 ftlb.) 

    3. 4.3  Tighten clamping screw 1  for locking cable using > T40031 - socket insert a/f 5  .

      > Tightening - torque 13 Nm (9.5 ftlb.) 

    4. 4.4  Press release 3  , actuate selector knob -2- and move selector lever from position "P" to "D" and from position "D" to "M" and back again several times.
      G15153161Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Selector support

  5. Install insulating mat -1-  .
    G15153162Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Insulating mat

    1. 5.1  Position insulating mat
    2. 5.2  Connect and lock cable plug -2- 
  6. Install switch console holder
    G15153163Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Switch console holder

    1. 6.1  Position switch console holder -1-  and lock it in -direction of arrow-  .
scientia non olet · About LEMON Manuals