LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2019 >> Macan Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (30 Clutch, Actuation 2.9L -- 95B - MACAN (95B)) >> WM, 304919 Removing And Installing Double Clutch >> Removing Double Clutch

Removing Double Clutch

WARNING: This page is about a different car, the 2024 Porsche Macan, 2023 Porsche Macan, 2022 Porsche Macan, 2021 Porsche Macan, and 2020 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position transmission on the mounting bracket with the gear shaft straight up.
  2. Detach double clutch cover -1-  .
    Fig 1: Double Clutch Cover Screws Loosening Sequence
    G15153117Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Cover on double clutch

    1. 2.1  Unscrew screws -2 to 6-  .
      1. 2.1.1  Replace screws.
  3. > T40123B - Lifting equipment -1-  must be fitted on the drive shaft -2-  .
    G15153118Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    T40123B Lifting equipment

    1. 3.1  Push T40123 A/1 - Sleeve -3-  onto the drive shaft -2-  .
    2. 3.2  Fit puller -4-  of the > T40123B - lifting equipment -1-  .
      1. 3.2.1  Position the puller -4-  in such a way that the edge of the puller -4-  engages under T40123 A/1 - Sleeve -3-  .
      2. 3.2.2  Close the puller -4-  and tighten knurled nut -5-  .
    3. 3.3  Check that the > T40123B - lifting equipment -1-  is fitted securely on the drive shaft.

    Information 

    • Do not allow particles of dirt to get into the transmission. 
  4. Remove double clutch -1-  from the transmission housing.
    G15153119Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    T40123B Lifting equipment with workshop crane

    1. 4.1  > T40123B - Lifting equipment-2-  must be engaged using > 10-222A/2 - additional hooks-3-  on the > VAS 6100 - workshop crane-4-  .
    2. 4.2  Lift the double clutch -1-  out of the transmission housing.
      1. 4.2.1  Clean sealing face on transmission housing close to the double clutch.
  5. Set double clutch -1-  and cover -2-  down on a soft surface. Make sure not to damage the bar -3-  while doing this.
    G15153120Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Double clutch

  6. > T40123B - Lifting equipment  can now be removed from the double clutch.
    1. 6.1  Loosen the knurled screw, open the puller and remove > T40123B - lifting equipment  from the double clutch.
    2. 6.2  Remove T40123 A/1 - Sleeve  from the drive shaft.

      Information 

      • The O-ring and circlip must be replaced. 

      Information 

  7. Remove double clutch cover
    G15153121Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Circlip on double clutch cover

    1. 7.1  Remove circlip -2-  .
    2. 7.2  Pull off double clutch cover
      1. 7.2.1  Clean sealing face on double clutch cover.