Technical Values
WARNING: This page is about a different car, the 2024 Porsche Macan, 2023 Porsche Macan, 2022 Porsche Macan, 2021 Porsche Macan, and 2020 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Connecting link to spring strut | Item 2: M10 x 45 thread/Always replace bolts following removal | Final tightening | + 90° | ||
| Level sensor to lower trailing arm | M6 thread | Tightening torque | 9 Nm | ||
| Spring strut to lower trailing arm | M12 thread/always use new screws or bolts and nuts following removal | Final tightening | + 90° | ||
| Upper trailing arm to wheel bearing housing | M10 thread | Tightening torque | 45 Nm | ||
| Damper fork to damper | M12 thread/always use new screws or bolts and nuts following removal | Final tightening | 90 Nm (66 ftlb.) | ||
| Damper fork to damper | M12 thread/always use new screws or bolts and nuts following removal | Final tightening | + 90° | ||
| Spring strut to lower trailing arm | M12 thread/always use new screws or bolts and nuts following removal | Initial tightening | 90 Nm (67 ftlb.) | ||
| Connecting link to spring strut | M10 x 45 thread/always use new screws or bolts following removal | Initial tightening | 40 Nm (30 ftlb.) | ||
| Tie-rod ball to wheel carrier cone | M12 x 1.5 thread/always use new nuts following removal | Tightening torque | 100 Nm (74 ftlb.) |