Installing Connecting Link For Anti-Roll Bar
WARNING: This page is about a different car, the 2024 Porsche Macan, 2023 Porsche Macan, 2022 Porsche Macan, 2021 Porsche Macan, and 2020 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
- Installation is performed in reverse order. Pay particular attention to the following:
Connecting link for anti-roll bar
- 1.1 Use new screws and nuts securing connecting link for anti-roll bar.
- 1.2 Fit and tighten nut -3-
securing connecting link -1-
to anti-roll bar and counter at the screw -2-
.
> Initial - tightening 40 Nm (30 ftlb.)
> Final tightening + 90°
- 1.3 Tighten screw -4-
securing connecting link -1-
to spring strut fork.
> Initial - tightening 40 Nm (30 ftlb.)
> Final tightening + 90°