Technical Values

WARNING: This page is about a different car, the 2024 Porsche Macan, 2023 Porsche Macan, 2022 Porsche Macan, 2021 Porsche Macan, and 2020 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.

Location	Description	Type	Basic value
Brake cover panel to wheel bearing housing (17-inch)	Item 2: Screw, M6 x 14	Tightening torque	10 Nm (7.5 ftlb.)
Courtesy of PORSCHE CARS NORTH AMERICA, INC. Brake cover panel, 17-inch
Tie-rod ball to wheel carrier cone	M12 x 1.5 thread/always use new nuts following removal	Tightening torque	100 Nm (74 ftlb.)
Level sensor to lower trailing arm	M6 thread	Tightening torque	9 Nm
Spring strut to lower trailing arm	M12 thread/always use new screws or bolts and nuts following removal	Initial tightening	90 Nm (67 ftlb.)
Spring strut to lower trailing arm	M12 thread/always use new screws or bolts and nuts following removal	Final tightening	+ 90°
Upper trailing arm to wheel bearing housing	M10 thread	Tightening torque	45 Nm
Clamp for axle joint (connection for lower trailing arm)	BM10 x 65 thread/always replace bolts following removal	Tightening torque	40 Nm (30 ftlb.)
Lower control arm to wheel bearing housing	M14 thread/always replace nuts following removal	Tightening torque	140 Nm (104 ftlb.)
Drive shaft to wheel hub	1st step (wheels suspended in air, press brake while tightening)/M1 6 x 72 thread/always use new screws following removal	Tightening torque	200 Nm (148 ftlb.)
Drive shaft to wheel hub	2nd step (wheels on the ground)/M16 x 72 thread/always use new screws following removal	Torque angle	180°