Subsequent Work
WARNING: This page is about a different car, the 2024 Porsche Macan, 2023 Porsche Macan, 2022 Porsche Macan, 2021 Porsche Macan, and 2020 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
- Installing heat shield front axle carrier.
> 404319 - REMOVING AND INSTALLING SHIELD (FRONT AXLE CARRIER) - PORTION ON "INSTALLING"
- 1.1 Tighten M6 screws: > Tightening - torque 9 Nm (6.5 ftlb.)
- 1.2 Tighten M8 screw: > Tightening - torque 20 Nm (15 ftlb.)
- Shock absorber fork (install spring strut fork).
> 408919 - REMOVE AND INSTALL SHOCK ABSORBER FORK - PORTION ON "INSTALLING"
- Tighten screw for drive shaft. -1-
- 3.1 Lower the vehicle as far as required so that the wheel is not on the floor.
- 3.2 Tighten the screw on the drive shaft -1-
to the specified initial tightening torque and get a helper to press the brake at the same time.
> Tightening - torque 200 Nm (148 ftlb.)
- 3.3 Lower the vehicle.
- 3.4 Tighten the screw on the drive shaft -1-
and also get a second mechanic to press the brake at the same time.
> Torque angle 180°
- 3.5 Fit wheel trim cover. -2-
Drive shaft screw