LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2019 >> Macan Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (40 Wheel Suspension Front Drive Shaft 2.9L -- 95B - MACAN (95B)) >> WM, 401819 Removing And Installing Control Arm >> Removing Control Arm

Removing Control Arm

WARNING: This page is about a different car, the 2024 Porsche Macan, 2023 Porsche Macan, 2022 Porsche Macan, 2021 Porsche Macan, and 2020 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Loosen control arm -1-  at the front-axle carrier.
    G15155783Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Control arm at front-axle carrier

    1. 1.1 Unscrew screw securing control arm to front-axle carrier -2-  and counter at the nut -3-  at the same time.
  2. Remove control arm -1-  .
    G15155784Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Control arm at wheel bearing housing

    1. 2.1 Unscrew nut -2-  as far as required from joint pin for tie-rod ball -3-  until it is flush with the upper edge of the joint pin -3-  .
    2. 2.2 Press off axle joint on control arm -1-  using > T10187 - ball joint puller  and remove it from the wheel bearing housing -4-  .
    3. 2.3 Unscrew nut -2-  from joint pin -3-  on the control arm -1-  , counter at the hexagon socket of the joint pin -3-  and remove control arm -1-  from the wheel bearing housing -4-  .
scientia non olet · About LEMON Manuals