LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2019 >> Macan Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (10 Engine - Crankcase, Suspension 2.9L -- 95B - MACAN (95B)) >> WM, 100119 Removing And Installing Engine (V6 Turbo) >> Preliminary Work

Preliminary Work

WARNING: This page is about a different car, the 2024 Porsche Macan, 2023 Porsche Macan, 2022 Porsche Macan, 2021 Porsche Macan, and 2020 Porsche Macan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the battery.
  2. Move bonnet into service position.
  3. Remove engine cover [design cover).
  4. Remove air cleaner housing.
  5. Remove torque support.
  6. Disconnect pressure hose at the throttle housing.
  7. Remove DME control unit.
  8. Remove front strut.
  9. Remove cowl panel cover.
  10. Remove filler neck from the washer-fluid reservoir.
  11. Remove front wheels.
  12. Remove front wheel housing liners.
  13. Loosen front brake callipers and hang them at a suitable position.
  14. Only for vehicles with PCCB brakes: 

    Remove front PCCB brake discs.

  15. Drain coolant.
  16. Remove rear cardan shaft.
  17. Remove front underbody cover.
  18. Disconnect pressure hose on charge-air cooler.
  19. Remove air-conditioning compressor.
  20. Disconnect ATF cooling line at the connection point.
  21. Loosen locking cable on transmission side.
  22. Only if the double clutch transmission must be removed: 

    Remove power-steering gear.

scientia non olet · About LEMON Manuals