LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2019 >> Macan Base >> Repair and Diagnosis >> Engine Mechanical >> Blowers, Superchargers & Turbochargers >> 21 Exhaust Gas Turbocharging 2.0L -- 95B - MACAN (95B) >> WM, 213919 Removing And Installing Moulded Hose (R4) >> Installing Moulded Hose >> Installing Moulded House (Charge Air Cooler - Pressure Pipe)

Installing Moulded House (Charge Air Cooler - Pressure Pipe)

  1. Installation is performed in reverse order. Pay particular attention to the following:
    1. 1.1  Tighten screw-type clamp on moulded hose at the bottom of the pressure pipe.
      • Tightening torque 5.5 Nm (4 ftlb.) 
    2. 1.2  Tighten screw-type clamp on left charge air cooler.
      • Tightening torque 5.5 Nm (4 ftlb.) 
scientia non olet · About LEMON Manuals