Installing Motor For Sun Blind
WARNING:
Electrically moved components
- Danger of limbs being trapped or severed
- → Switch off electric power to drive motor.
- → Make sure it does not switch on again.
- → Check that there is no electric charge.
Information
Always comply with the regulations or handling ESD-sensitive components!
- Always wear approved work clothes and shoes when carrying out assembly work.
- Do not remove new parts from ESD (electrostatic discharge) protective packaging until shortly before installation.
- Do not touch electric pins and plug contacts.
- Installation is performed in reverse order. Pay particular attention to the following:
Replace screws securing sun blind motor to glass sliding roof frame and tighten to > Tightening - torque 2 Nm (1.5 ftlb.) .