Subsequent Work

Information 

After installing the sun blind, check that it moves perfectly and smoothly. To do this, move the sun blind drive mechanism forwards and backwards at the motor by hand by actuating it manually using a commercially available hexagon wrench and check that the sun blind fabric folds and moves correctly. 

1. Install rear sliding-roof panel.

   > 604019 - REMOVING AND INSTALLING REAR SLIDING-ROOF PANEL 

2. Install headliner.

   > 708419 - REMOVING AND INSTALLING HEADLINER

3. Re-initialise end positions of the sun blind.
   1. 3.1  Switch on the ignition.
   2. 3.2  Press sun blind button forward and keep it pressed.
   3. 3.3  Close the sun blind as far as its limit stop and then open it again.
   4. 3.4  The sun blind button must remain pressed for the entire duration of the standardisation run.
   5. 3.5  Release the sun blind when the standardisation run is complete.