Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Clamp for anti-roll-bar mount to rear axle housing | Item 2: Internal serration screw, M8 x 25/Always replace screws following removal | Initial tightening | 25 Nm (22 ftlb.) (18.4 ftlb.) | ||
|
Clip on Stabiliser mount |
|||||
| Clamp anti-roll bar mount to rear axle housing | Item 2: Internal multipoint screw M8 x 25/Always replace screw following removal! | Final tighten torque | ling + 90° | ||
|
Clip on anti-roll-bar mount |
|||||