LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2019 >> Cayenne Turbo >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 26 (40 Wheel Suspension Front Drive Shaft 3.0L -- 9YA - Cayenne (9YA)) >> WM, 407719 Removing And Installing Front Anti-Roll Bar (PDCC) >> Installing Front Anti-Roll Bar (PDCC) >> Installing Front Anti-Roll Bar

Installing Front Anti-Roll Bar

WARNING: This page is about a different variant/trim than selected.
  1. Installation is performed in reverse order. Pay particular attention to the following:
    1. 1.1  Tighten screws on anti-roll bar clamps.

      > Tightening torque 55 Nm (41 ftlb.) 

    2. 1.2  Tighten nut on ground line.

      > Tightening torque 16 Nm (12 ftlb.) 

scientia non olet · About LEMON Manuals