Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Nuts securing line bracket to cylinder head cover | Tightening torque | 9 Nm (6.5 ftlb.) | |||
| Nuts securing holder to cylinder head cover | Tightening torque | 9 Nm (6.5 ftlb.) | |||
| Screws for cylinder head cover on right cylinder bank | Replace following removal. | Initial tightening | 8 Nm (6 ftlb.) | ||
| Screws for cylinder head cover on right cylinder bank | Replace following removal. | Torque angle | + 90° | ||
| Screws for cylinder head cover on left cylinder bank | Replace following removal. | Initial tightening | 8 Nm (6 ftlb.) | ||
| Screws for cylinder head cover on left cylinder bank | Replace following removal. | Torque angle | + 90° | ||
| Vacuum line holder | M6 screw | Tightening torque | 9 Nm (6.5 ftlb.) |