LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2019 >> Cayenne Turbo >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (70 Linings, Insulation (Coupe) -- 9YB - Cayenne (9YB)) >> WM, 70691930 Removing And Installing D-Pillar Trim Panel >> Removing D-Pillar Trim Panel

Removing D-Pillar Trim Panel

WARNING: This page is about a different car, the 2023 Porsche Cayenne, 2022 Porsche Cayenne, 2021 Porsche Cayenne, and 2020 Porsche Cayenne. However, it is still accessible from the selected car via links, so may be relevant.

Information 

To reduce the forces during removal and thereby the risk of damage, a suitable tool must be used as a support during removal at accessible connection points.

  1. Detach seal on rear lid -1-  in the D-pillar trim panel area.
    G15240357Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Rear lid seal

  2. Unclip clips -2-  and remove D-pillar trim panel -1-  from the D-pillar.
    G15240358Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    D-pillar trim panel

    NOTIFICATION 

    Voltage peaks 

    • Risk of damage to electrical load or to the control unit 
      1. → Switch off ignition and keep transmitter key outside of the transmission range (at least 5 m).
      2. → Switch off electrical loads before disconnecting or removing them.
  3. Release and disconnect electric plug connections -1-  from loudspeakers -2-  .
G15240359Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Electric plug connections