Removing Wire Harness For Rear Door (BODYSHELL)
Information
The number of electric plug connections will vary depending on equipment.
- Release and unplug electric plug connection -2-
.
Electric plug connection
- Press rubber sleeve -1-
upwards -arrow A-
and unclip it by pulling it outwards -arrow B-
.
Rubber sleeve
- Press rubber sleeve -1-
inwards and guide section of line through towards the inside.
Rubber sleeve
- Release and unplug electric plug connections -1-
.
Electric plug connections
- Disconnect wire harness for rear door (bodyshell).
Wire harness for rear door (bodyshell)
- 5.1 Release and unplug electric plug connection -1- .
- 5.2 Unclip wire harness for rear door (bodyshell) - Arrows- .
- 5.3 Press rubber sleeve -2- inwards.
- Remove bracket for closing aid.
Closing aid bracket
- 6.1 Disengage wire harness for rear door (bodyshell) -1- .
- 6.2 Open locks -2- by turning them anti-clockwise.
- 6.3 Remove closing aid bracket.
- Release and unplug electric plug connections -1-
.
Electric plug connections
- Unclip wire harness for rear door (bodyshell) -1-(-Arrows-)
.
Wire harness for rear door (bodyshell)
- Unclip wire harness for rear door (bodyshell) -1-arrow B-
and guide it through the opening -arrow B-
.
Wire harness for rear door (bodyshell)
- Press rubber sleeve -1-
through and unclip wire harness for rear door (bodyshell) -2-
.
Rubber sleeve for wire harness for rear door (bodyshell)
- Guide wire harness for rear door (bodyshell) through and remove it.