Installing Rear Axle

Installation is performed in reverse order. Pay particular attention to the following:
1. 1.1 Replace screws securing rear axle housing to the body.
2. 1.2 Tighten screws securing rear axle housing to the body.
  > Initial tightening 130 Nm (96 ftlb.)
  
  > Final tightening + 180°
3. 1.3 Tighten front screws securing strut to the body.
  > Tightening torque 49 Nm (36.1 ftlb.)
4. 1.4 Tighten screws securing shock absorber to the body.
  > Initial tightening 50 Nm (36.9 ftlb.)
  
  > Final tightening + 90°
5. 1.5 Tighten rear screw securing strut to the body.
  > Initial tightening 50 Nm (36.9 ftlb.)
  
  > Final tightening + 45 (33 ftlb.) °
6. 1.6 Tighten screw securing left strut to right strut.
  > Tightening torque 25 Nm (18.5 ftlb.) (18.4 ftlb.)
7. 1.7 Tighten nuts on stone guard for valve unit.
  > Tightening torque 9 Nm (6.5 ftlb.)
8. 1.8 Tighten nut on ground line for PDCC anti-roll bar.
  > Tightening torque 16 Nm (12 ftlb.)