Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Connecting rod bolts | Initial tightening | 50 Nm (37 ftlb.) | |||
| Connecting rod bolts | Final tightening | + 90° | |||
| Screw securing oil windage tray to crankcase | M6 x 18 (3 ea.)/rep lace, tighten crosswise | Initial tightening | 3 Nm (2 ftlb.) | ||
| Screw securing oil windage tray to crankcase | M6 x 18 (3 ea.)/rep lace, tighten crosswise | Final tightening | + 90° | ||
| Screw securing oil windage tray to crankcase | M6 x 30 (13 ea.)/rep lace, tighten crosswise | Initial tightening | 3 Nm (2 ftlb.) | ||
| Screw securing oil windage tray to crankcase | M6 x 30 (13 ea.)/rep lace, tighten crosswise | Final tightening | + 90° | ||
| Screw securing chain housing cover to oil guide housing | M6 x 25 (6 ea.)/rep lace, observe tightening sequence | Initial tightening | 3 Nm (2 ftlb.) | ||
| Screw securing chain housing cover to oil guide housing | M6 x 25 (6 ea.)/rep lace, observe tightening sequence | Final tightening | + 90° |