Subsequent Work
WARNING: This page is about a different variant/trim than selected.
- After an oil change on the transfer gear, the wear values must be reset using the PIWIS Tester .
- PIWIS Tester must be connected to the vehicle.
- Select All-wheel drive electronics (PTM) control unit.
- Select the Drive links/checks menu.
- Select the menu item "Reset learning values after the oil change" by pressing F12 and then press F8 to start.
- Install cover for front underbody
> WM, 519219 REMOVING AND INSTALLING COVER FOR FRONT UNDERBODY
- Following assembly and after a successful Tester routine, perform a short run-in drive for 3 minutes on the road at a speed of about 20 km/h (12 mph) .