Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Differential cover to transmission | Screw M8 x 35 (V6: 8 x//V8, 15 x) - observe tightening sequence | Tightening torque | 35 Nm (25.8 ftlb.) | ||
| Differential cover on transmission | Screw, M10 x 47 (V6 only: 3 x) - Observe specified tightening sequence | Tightening torque | 47 Nm (34.66 ftlb.) | ||
| Flanged-shaft mounting saddle to transmission | Screw, M8 - replace screw | Initial tightening | 9 Nm (6.5 ftlb.) | ||
| Flanged-shaft mounting saddle to transmission | Screw, M8 - replace screw | Final tightening torque angle | 60° |