Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Upper trailing arm to wheel bearing housing | Hexagon-head bolt, M10 x 130 and hexagon nut | Tightening torque | 40 Nm (30 ftlb.) | ||
| Connecting link to spring strut (conventional) | 12 point socket, M10 x 85 and hexagon nut/always replace bolts and nuts following removal! | Initial tightening | 40 Nm (30 ftlb.) | ||
| Connecting link to spring strut (conventional) | 12 point socket, M10 x 85 and hexagon nut/always replace bolts and nuts following removal! | Final tightening | + 90° | ||
| Connecting link to spring strut (PDCC) | 12 point socket, M12 x 85 and hexagon nut/always replace bolts and nuts following removal! | Initial tightening | 60 Nm (44 ftlb.) | ||
| Connecting link to spring strut (PDCC) | 12 point socket, M12 x 85 and hexagon nut/always replace bolts and nuts following removal! | Final tightening | + 90° | ||
| Spring strut fork to lower trailing arm | Hexagon-head bolt, M12 x 85 and hexagon nut/always replace bolts and nuts following removal! | Initial tightening | 90 Nm (67 ftlb.) | ||
| Spring strut fork to lower trailing arm | Hexagon-head bolt, M12 x 85 and hexagon nut/always replace bolts and nuts following removal! | Final tightening | + 90° | ||
| Spring strut to spring strut fork | Hexagon-head bolt, M12 x 95 and hexagon nut/always replace bolts and nuts following removal! | Initial tightening | 40 Nm (30 ftlb.) | ||
| Spring strut to spring strut fork | Hexagon-head bolt, M12 x 95 and hexagon nut/always replace bolts and nuts following removal! | Final tightening | + 180° |