Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| diagonal arm to front-axle carrier | Item 6: Hexagonal screw M12 x 140 and hexagon nut/always replace screws and nuts following removal! | Initial tightening | 70 Nm (51.6 ftlb.) | ||
| Diagonal arm to front-axle carrier | Item 6: Hexagon-head screw M12 x 140 and hexagon nut/always replace bolts and nuts following removal! | Final tightening | + 180° | ||
| Diagonal arm to wheel bearing housing | Item 7: Hexagon nut M14 x 1.5/always replace nut following removal! | Tightening torque | 140 Nm (103.3 ftlb.) | ||
| Heat insulation on front axle carrier | Hexagon-head bolt M6 x 16 | Tightening torque | 9 Nm (6.6 ftlb.) | ||
| Heat insulation to longitudinal chassis beam | Hex bolt M6 x 12/applies to one-piece heat insulation. | Tightening torque | 9 Nm (6.5 ftlb.) (6.6 ftlb.) | ||
| Heat insulation (upper part) to heat insulation (lower part) | M6 hex bolt x 20/applies to two-piece heat insulation! | Tightening torque | 9 Nm (6.5 ftlb.) (6.6 ftlb.) | ||
| Heat insulation (upper part) to longitudinal chassis beam | M6 hex bolt x 20/applies to two-piece heat insulation! | Tightening torque | 9 Nm (6.5 ftlb.) (6.6 ftlb.) |