Subsequent Work

WARNING: This page is about a different variant/trim than selected.

Install front axle.
> Removing and installing front axle
Tighten screws for power-steering gear.
> Initial tightening 80 Nm (59 ftlb.)

> Final tightening + 180°
Tighten control arm screws.
1. 3.1 Before tightening the control arm screws: Lift the wheel suspension up slightly using lifting equipment (e.g. > VAS 6931 - Transmission and Engine Jack ).
2. 3.2 Tighten control arm screws.
  > Initial tightening 70 Nm (51.6 ftlb.)
  
  > Final tightening + 180°