Installing Steering Wheel

WARNING: This page is about a different variant/trim than selected.

Information

Turn wheels to straight-ahead position and observe the markings you applied earlier!
When replacing the steering wheel, replace the internal serration screw and secure according to tightening specifications.

Installation is performed in reverse order. Pay particular attention to the following:

When fitting the steering wheel, make sure that the markings between the steering wheel and steering column are aligned.
Use new internal serration screw -1- and tighten as follows:
> Initial tightening 30 Nm (22.1 ftlb.) > Final tightening torque angle 90°

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Multiple-tooth screw