Installing Mounting Saddle

WARNING: This page is about a different variant/trim than selected.

Installation is performed in reverse order. Pay particular attention to the following:
1. 1.1 Tighten brake booster to the pedals.
  > Tightening torque 25 Nm (19 ftlb.)
  
  > 477019 REMOVING AND INSTALLING BRAKE BOOSTER - on "Installing"
2. 1.2 Tighten nuts securing mounting saddle to firewall.
  > Tightening torque 8 Nm (6 ftlb.)
3. 1.3 Tighten screw securing mounting saddle to retaining frame.
  > Tightening torque 20 Nm (15 ftlb.)